You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
{{ message }}
This repository has been archived by the owner on Apr 17, 2022. It is now read-only.
When commanders are created and factories are assigned to them,
pressing F6 to open Commander view and clicking on each of them
properly shows the assigned factory.
However, when commanders are assigned and switched using keys
(Ctrl+1,2,3...), then pressing 1,2,3 consecutively does not clear
the assigned factory status from previous commander.
(So if one presses 1,2,3, the third commander (assigned to 3)
seems as it has factories 1, 2 and 3 assigned to it in the
detailed view on the left).
Issue migrated from trac:1131 at 2022-04-15 20:09:05 -0700
The text was updated successfully, but these errors were encountered:
resolution_fixed
type_bug
| by bugreports@...When commanders are created and factories are assigned to them,
pressing F6 to open Commander view and clicking on each of them
properly shows the assigned factory.
However, when commanders are assigned and switched using keys
(Ctrl+1,2,3...), then pressing 1,2,3 consecutively does not clear
the assigned factory status from previous commander.
(So if one presses 1,2,3, the third commander (assigned to 3)
seems as it has factories 1, 2 and 3 assigned to it in the
detailed view on the left).
Issue migrated from trac:1131 at 2022-04-15 20:09:05 -0700
The text was updated successfully, but these errors were encountered: